Input nonappearance in output pane

This forum is to report technical problems with Rel.
Post Reply
Joined:Sat May 24, 2008 4:49 pm
Input nonappearance in output pane

Post by HughDarwen » Wed Jan 10, 2018 4:10 pm

Here's a strange one (in Windows 10). Sometimes my input from the lower pane in command mode doesn't appear above the result in the upper pane. However, when I save the upper pane as html, it does then appear in the html file!
Below are a couple of screenshots illustrating this phenomenon.

Input in lower pane not shown in upper
InputNonAppearance.JPG (83.59KiB)Viewed 1780 times
Input appears in saved html.
ButShowsInSavedHTML.JPG (66.71KiB)Viewed 1780 times

Site Admin
Joined:Sun Nov 27, 2005 7:19 pm

Re: Input nonappearance in output pane

Post by Dave » Thu Jan 18, 2018 11:13 pm

Try checking "Preferences | Command line | Use an alternative output display to try to fix output problems."

The standard output is actually hooking into the default Web browser. Depending on the version and type of default Web browser, it sometimes breaks, and the alternative output display will get around it (at the expense of perhaps slightly reduced performance.)

Post Reply