Input nonappearance in output pane

This forum is to report technical problems with Rel.
Post Reply
HughDarwen
Posts: 124
Joined: Sat May 24, 2008 4:49 pm

Input nonappearance in output pane

Post by HughDarwen »

Here's a strange one (in Windows 10). Sometimes my input from the lower pane in command mode doesn't appear above the result in the upper pane. However, when I save the upper pane as html, it does then appear in the html file!
Below are a couple of screenshots illustrating this phenomenon.

Hugh
Input in lower pane not shown in upper
Input in lower pane not shown in upper
InputNonAppearance.JPG (83.59 KiB) Viewed 7496 times
Input appears in saved html.
Input appears in saved html.
ButShowsInSavedHTML.JPG (66.71 KiB) Viewed 7496 times
Dave
Site Admin
Posts: 372
Joined: Sun Nov 27, 2005 7:19 pm

Re: Input nonappearance in output pane

Post by Dave »

Try checking "Preferences | Command line | Use an alternative output display to try to fix output problems."

The standard output is actually hooking into the default Web browser. Depending on the version and type of default Web browser, it sometimes breaks, and the alternative output display will get around it (at the expense of perhaps slightly reduced performance.)
Post Reply